Скачать или смотреть how to replace fuser film sleeve HP laserjet p2015 1320 1160 printer

Replacing the fuser film sleeve in an HP LaserJet P2015, 1320, or 1160 printer can be done by following these general steps:

Turn off the printer and unplug it from the power source.

Wait for the printer to cool down for at least 30 minutes.

Open the printer's rear cover and remove the rear output tray if it is attached.

Remove the fuser assembly by pressing the release button or lever.

Place the fuser assembly on a clean, flat surface.

Loosen and remove the screws or clips that secure the fuser film sleeve to the fuser assembly.

Carefully remove the old fuser film sleeve from the fuser assembly, taking care not to damage any of the other components.

Clean the fuser assembly thoroughly with a lint-free cloth to remove any debris or excess toner.

Install the new fuser film sleeve onto the fuser assembly, making sure it is properly aligned and secured with the screws or clips.

Reinstall the fuser assembly into the printer and make sure it is properly locked into place.

Close the rear cover and reattach the rear output tray if necessary.

Plug the printer back in and turn it on.

Run a test print to ensure that the fuser is working properly.

It's important to note that the exact steps for replacing the fuser film sleeve may vary depending on the specific model of the printer. It's recommended to refer to the printer's manual or manufacturer's website for specific instructions. Additionally, replacing the fuser film sleeve can be a complex and delicate process, and it may be best to seek assistance from a trained technician if you are unsure about performing the replacement yourself.