Скачать или смотреть Harbor Freight Bauer Spindle Sander 56870 Test (not good)

Excited to get the Oscillating Edge Belt And Spindle Sander from Harbor Freight. The excitement was short lived as I noticed the belt was not square to the table! I made some marks on the wood. You can see that the marks are gone on the bottom. If you sand until the marks are gone, the wood is now out of square!

Video shows a reasonably square piece of stock placed against the sanding attachment. It ALWAYS makes a bevel cut, deeper on the bottom. The table is perfectly flat.

As the belt comes up, you can feel it push the stock back at you!

This belt is off by about 1/8 of an inch from the bottom to the top!

Hope this is just a fluke. Will return and try another.

But if you are looking at the 56870 - TEST it !