Скачать или смотреть Enroll DSC PG9303 to IQ Panel 2 Plus

In this video, Michael from Alarm Grid shows you how to enroll the DSC PG9303 to a Qolsys IQ Panel 2 Plus. The DSC PG9303 is a PowerG Door and Window Sensor that can be enrolled with the system in one of two (2) ways. You can auto-enroll the sensor by putting the IQ Panel 2 Plus in auto-learn mode and then powering on the sensor. Or you can manually enter the sensor's Serial Number. If you perform manual enrollment, then you must activate the sensor's tamper cover to complete the enrollment process. The act of activating the sensor's tamper cover shares the encryption key between the sensor and the panel. The enrollment process isn't fully completed until the tamper cover is activated if the Serial Number was entered manually.

As a PowerG Door and Window Contact Sensor, the DSC PG9303 offers some great features. It can be used with any Qolsys IQ Panel 2 Plus System, as all versions of the IQ Panel 2 Plus have PowerG daughtercards. The sensor will work with the IQ Panel 2 Plus from up to 2,000 feet away in an open air environment. The DSC PG9303 uses 128-bit AES encryption when communicating with the IQ Panel 2 Plus, which prevents others from spoofing or hacking the sensor. This also prevents RF jamming techniques that could otherwise block signals from going through successfully. The sensor is powered by a single lithium CR2450 coin battery. It has a slim profile that helps it remain less noticeable on doors and windows. The sensor must be aligned properly with its included magnet for successful operation. There are indentations on the side of the sensor to assist users with aligning the magnet. The magnet spacing gap for the sensor is about half an inch. The sensor is for indoor use only.

https://www.alarmgrid.com/faq/how-do-...

http://alrm.gd/get-monitored