Sovol SV08 X End Stop, Klicky & nozzle LED Install

After the First Video when we have presented the Shroud V3 and all the benefits that it had with over 230 download on Printables we had a lot of questions on how to connect all the cables. how to klicky works and a lot of other questions + a lot of people has complained that the first video that it was a live stream it was too long to watch so i have dismantle the 3d printer, it took me more than 10 hours, to make this video I will apricate a like. hope that with this video I have answered all the questions. if you have any other questions please leave them in the comments.

where you can download the parts? here you will find also all the firmware part that you need to add/delete in the printer.cfg

https://www.printables.com/model/9387...



Toolhead Board FAN

[controller_fan extra_controller_fan]
pin: extra_mcu:PB0
fan_speed: 0.5
The fan speed (expressed as a value from 0.0 to 1.0) that the fan
will be set to when a heater or stepper driver is active.
The default is 1.0
idle_timeout: 60
The amount of time (in seconds) after a stepper driver or heater
was active and the fan should be kept running. The default
is 30 seconds.
idle_speed: 0.3
The fan speed (expressed as a value from 0.0 to 1.0) that the fan
will be set to when a heater or stepper driver was active and
before the idle_timeout is reached. The default is fan_speed.
heater: extruder



read the full description on printables to update all the firmware in the printer.cfg