50 Most Important MCQ,s | Highway or Road Engineering | Exam Help Center

50 Most Important MCQ,s | Highway or Road Engineering | Exam Help Center
#Examhelpcenter
#Exam_Help_Center
#mcq
#highway_engineering
#pheexam
#mcq


In thie video, 50 most important multiple choice question discuss about the chapter- Road or Highway Engineering

All the question will help you for the exam of APSC, SSC, UPSC, WBPSC, RALWAY, et.



0:00 Introduction
0:15 For transportation purposes in India, the first preference is given to
0:31 The term used for major or important roads of a country is
0:46 A road connecting two towns is called a
1:01 The portion of a road surface, which is used by vehicular traffic, is known as
1:18 The city roads which are meant for through traffic usually on a continuous route are known as
1:35 The central portion of a road for high speed vehicles is known as
2:07 The longest road constructed during the time of Shershah Suri was from.
2:22 The grand trunk (G.T.) road was constructed during
2:38 The roads connecting capital cities of states is called
3:27 The Central Road Organisation (C.R.O.) was set up in
3:43 The Indian Roads Congress (I.R.C.) was set up in
4:12 The Central Road Research Institute (C.R.R.I.) was started in Delhi, in.
4:29 The Central Road Research Institute is
5:05 The headquarter of the Indian Roads Congress is at
5:21 The Indian Roads and Transport Development Association (I.R.T.D.A.) was set up in.
5:37 The headquarter of the Indian Roads and Transport Development Association is at
5:54 The Border Roads Development Board was established in.
6:10 In Nagpur conference, the minimum width of
6:26 For the water-bound macadam road, the recommended camber is.
6:42 The camber, for the drainage of surface water, was first introduced by.
6:58 National Highways Act, 1956 came into force from
7:13 In water-bound Macadam roads.
7:28 According to Indian Roads Congress, the maximum width of a road vehicle is.
7:45 In order to give satisfactory service throughout the year, the road surface should
8:01 The top of the ground on which the foundation
8:22 The foundation of a road is also called.
8:37 The super structure of a road is called.
8:52 The thickness of base, in no case, should be more than
9:07 The highest point on road surface is called.
9:22 The road surfacing should be.
9:37 The slope of the line joining the crown and edge of the road surface is known as.
9:53 The thickness of road surfacing depends upon the.
10:08 The main object of providing a camber is.
10:23 In scanty rainfall areas, the camber provided will be.
10:38 On kankar road, the camber generally provided is.
10:54 The shape of the camber provided for cement concrete pavement is.
11:10 A camber consisting of two straight slopes
11:26 The camber recommended for water bound macadam roads in.
11:42 The camber of road should be approximately
12:00 The inward tilt given to the cross-section of the road surface, throughout the length of the
12:18 The rising of outer edge of the road above the inner edge is known as
12:35 The rate of rise or fall of the road surface along its length is called
12:50 The gradient of road depends upon the.
13:05 The value of maximum gradient for hill roads
13:20 The value of ruling gradient in plain, as recommended by Indian Roads Congress, is.
13:37 The value of ruling gradient in hills, as