HARSLE Genius Press Brake Operation Tutorial (DELEM DA-66T and DA-69T)

#pressbrake #tutorial #HARSLE
When you receive the press brake machine or when you run the hydraulic bending machine for the first time. You may have doubts about how to use it in a proper way. Here will be the good news for you. We definitely believe that HARSLE Genius press brake machine ultimate operation tutorial for DELELM DA-66T and DA-69T will help you.

Part 1: Fill The Oil and Cable Connections
Controller Cable Connection
Filling The Oil Tank with Anti-Wear Hydraulic Oil
Fill The Oil from This Port
No less than 2/3 of the Oil Volume Level
Connect The Machine to Power Source
Connect The Cable to The Electrical Box
Connect The Earth Wire
Connect To 3 Phase Power Source
Switch On the Power Source
Turn On the Machine Power Switch
Waiting For the System Loading
Check The Main Motor Rotating Direction
Pull Down the Soft Buttons
Press the Pump-Start Button Shortly
Check The Main Motor Rotating Direction
If It Rotates Clockwise, Then It Is Correct
It Is Rotating Anti-Clockwise
Exchange the Two Wires Connection

Part 2: Machine Start-up
Turn On the Machine Power Switch
Waiting For the System Loading
Release the Emergency Stop Switch
Pull Down the Soft Buttons
Press the Pump-Start Button
Press Start Button and Find Reference Points
Finding Reference Points Is Done
Test the X-axis Running
Test The Crowning System Running
Check The Tooling Parameters
Measure The Tooling to Compare with The Date

Part 3: Bending Programming
Enter The Password 42
Enter The Program Name
Input The Sheet Thickness
Selecting The Tooling
Input The Sheet Length
Input The Bending Angle
Enter The X-Axis Distance
Add Another Bending Step
Check Program Data
Ready To Start

Part 4: Bending Products
Placing The Metal Sheet
Sheet Will Touch The Stop Fingers
Step The Foot Pedal
Complete Step 1
Press The Pedal
Complete Step 2

Part 5: Measurement And Calibration
Measuring The First Bending Distance
Measuring The Second Bending Distance
Using The Angle Ruler
Measure The Bending Angles In Three Positions: Left, Middle And Right
Error Found Was Found In Left Position
Measured At 89°
The Left Side Is Corresponds To The Y1 Axis
Enter The Calibration Parameters For Y1 Axis
Bend Again For Testing
Measure To Check
It Is Correct Now

Part 6: 2D Graphic Programming

Part 7: 3D Graphic Programming (only for DA-69T)

Part 8: Offline Software

Part 9: Switch Off
Step The Foot Pedal to Lower the Punch Against The Die
Press Stop Button
Switch Off the Pump
Press The Emergency Stop Buttons
Turn Off the Power Switch

Contact Us
https://www.harsle.com​​
Email: [email protected]
WhatsApp: +86 18052080815