Usage ST-LINK V2 Tutorial. STM32 Programming for Beginners. Cheap clone ST-Link comparation

In this video you will learn how to program STM32 microcontrollers using STLink. You will also see the difference between the original STLink and its cheap clone.
Links for software and electronics:

ST-Link Utility (works with clones)
https://www.st.com/en/development-too...

STM32CubeProgrammer (doesn't work with clones)
https://www.st.com/en/development-too...

ST-LINK/V2 Programmer 20PIN Out (Clone)
https://ali.ski/ZLIXl
https://ali.ski/Qn76s

ST-LINK/V2 10PIN Out
https://ali.ski/aaVLYu
https://ali.ski/BBgtvJ

STM32F401/STM32F411 Development Board (84Mhz 96KB RAM 512KB FLASH/100Mhz 128KB RAM 512KB FLASH):
https://ali.ski/071JN
https://ali.ski/uabCzN
https://ali.ski/ulk8HT
https://ali.ski/LOG_c
https://ali.ski/iE2nP

STM32F030F4P6 Development Board (48MHz 4kB RAM 16kB FLASH):
https://ali.ski/2BVjR
https://ali.ski/wN2uY6
https://ali.ski/NuN0t
https://ali.ski/JzQdIC

--------------------------------------

Links:
My web: http://nanoslavic.com/
Twitter:   / nanoslavic  
Instagram:   / nanoslavic  
My art http://nudeelectronics.art
Free photos of electronics https://pixabay.com/users/nanoslavic-...
My Russian Channel:    / @nanoslavic  

*NOT SPONSORED, SOME LINKS ARE AFFILIATE LINKS

#STM32 #Nanoslavic #STLink #STM32Tutorial #diyelectronics #Arduino #STM32Programming

0:00 Вступление
0:33 ST-Link V2 Cheap clone
0:48 STM32F030F4P6 Development Board
1:02 STM32F401CCU6 Development Board
1:29 I am using ST-Link Utility
2:20 Update ST-Link firmware
2:46 Connect to microcontroller
3:06 Open the firmware binary
3:10 LED blink firmware
3:19 Start programming
3:36 Disconnect from the microcontroller
5:01 Connect to the microcontroller
5:05 Erase memory
5:16 Reset pin allows faster entry into programming mode.
6:33 The chip without marking
6:39 Original
7:48 1.27 mm pitch connector