Frost Fighter Heaters - How to Set the Electrode Gaps (IDF Oil/Diesel)

The intention of this Service Video is to demonstrate the procedure to set and adjust the electrode spacing on the burner electrode assembly.
Use for FrostFighter IDF and OHV Oil/Diesel Fired Units

Procedure:
00:20 Step 1: Remove burner electrode assembly from blast tube.

01:45 Step 2: On the top of the burner electrode assembly there is a single screw in the center which holds the electrode insulator kits in place. Loosen this screw just enough so that you can move the electrode insulator kits.

02:05 Step 3: With this screw loosened, slide and adjust the electrode insulator kits to desired location, use a T501 gauge to help guide you.
NOTE: When making these adjustments you should follow the suggested distances for these three parameters: Nozzle centerline to electrode tip, nozzle face to electrode tip, and electrode spacing.

03:18 Step 4: Once you are satisfied with the position of the electrodes, tighten the single center screw on the burner electrode assembly to lock the electrode insulator kits in place.

03:58 Step 5: Replace the burner electrode assembly back into the blast tube.

Check out our channel for new videos or go to:

www.frost-fighter.com