How To Power Your Zooz ZSE70 Outdoor Motion Sensor With 12-24 V 💡

You can power your Zooz Outdoor Motion Sensor with the included CR123A batteries or from an existing 12-24 V source (AC or DC works). The necessary accessories to keep the sensor sealed come in the box but you need to make sure you have the appropriate power supply and a small flat head screwdriver to complete the installation.

Curious about this sensor?
🛒 Shop here: https://bit.ly/4dZRHha
❓ Support: https://bit.ly/3Xm3ktn

How to install 12-24 V power source on the ZSE70 Outdoor Motion Sensor:
1. Unscrew the head cap from the bottom of the sensor.
2. That will expose the wire terminals.
3. Then take out the top cap from the accessory kit.
4. Press out the outline button inside.
5. Thread your wires through the accessories in this specific order:
6. First the dome cap, then the rubber seal, and finally the frilled spacer.
7. Next, insert your wires into the push-tab terminals.
8. Press down on the exposed plastic to open the terminal.
9. Insert the wires checking the correct polarity.
10. Make sure the wires are secured.
11. Cover the wires with the spacer. The seal goes inside of the spacer.
12. Twist the dome cap over the spacer to secure the installation.
And that's it, you're done!

#zoozhome #zwave #smartgadgets #smarthomesecurity #smarthome #smartsensors