Скачать или смотреть Danfoss thermostat WT P SETUP

Danfoss WT-P BasicPlus2 programing setup:

The digits indicate the set value as follows:
P01 Working mode 01-Manual, 02-Advanced Programmable Timer
P02 Temperature control mode 01-Only Room Temperature, 02-Room and Floor temperature control (only if floor sensor is installed)
P03 High room temperature limit 5-35°C (Only for 01 and 02 in P02)
P04 Low room temperature limit 5-35°C (Only for 01 and 02 in P02)
P05 Floor temperature limitation mode 01-High temperature limitation, 02-Low temperature limitation (only for 02 in P02)
P06 Floor temperature limitation setpoint 20-45°C (Only for 02 in P02)
P07 High floor temperature limit 20-45°C (Only for 03 in P02)
P08 Low floor temperature limit 20-45°C (Only for 03 in 02)
P09 Frost protection 01-Enable, 02-Disable
P10 Frost protection setpoint 5-17°C
P11 Timer display option 01-24h, 02-12h
P12 Room temperature display option at shutdown 01-No display current temperature, 02-Display current temperature

P03 to P08 appear on relevant temperature control mode

Error Messages
E1 - Room sensor failure
E2 - Floor sensor failure
EE - EEPROM failure
Lo - Temperature lower than 0°C
Hi - Temperature higher than 50°C