CAFE RACER BUILD Part 3 | Frame Jig Fabrication | Coping With Coping! TRIUMPH, NORTON, FEATHERBED

Rob continues the Café Racer build project. In this episode, we get into building a riser for the repeatable mounting of the rear swingarm frame tabs. Then, we look at techniques and tips for coping frame tubes as fitted to the steering neck. Presents practical fundamentals and procedures that can be applied to ANY café racer build.

Tube notching and coping calculator used in this episode:
https://www.hpacademy.com/notching-ca...

Media Provided by Pond5:

https://www.pond5.com/royalty-free-mu...
Stock Media provided by stevericemusic / Pond5

https://www.pond5.com/royalty-free-mu...
Stock Media provided by jwsaudio / Pond5

https://www.pond5.com/royalty-free-mu...
Stock Media provided by ChezGroove / Pond5

https://www.pond5.com/royalty-free-mu...
Stock Media provided by Marscott / Pond5

#caferacer #motorcycle #nortonmotorcycles

USE DISCLAIMER:
Every workplace is different and the procedures shown or described in this video content are general rather than specific. Viewers may notice variations in operations and safe work practices. Changent endorses performing work at the highest level of incident-preventive behaviors. The viewer/user should always comply with all current and up-to-date federal, state and local laws. Local/State and Federal laws and/or company policies and requirements supersede any content presented in this video. Changent Systems, LLC is not responsible for any loss or damages for the use of the information contained herein. No warranty is made that the procedures described will not infringe third party patents.