Скачать или смотреть Building a Two-layer, Through-hole PCB in EasyEDA Pro (for an AVR64DU28 Microcontroller board)

In this video, I walk through the complete design of a two-layer, through-hole PCB using EasyEDA Pro. The board is based on a Microchip AVR64DU28 microcontroller (MCU). Mistakes were made, so check out my corresponding blog post for additional details. :)

** Continued at    • AVR64DU28 MCU - Board Assembly & Basic Tes...  .

Related blog post: https://www.rehsdonline.com/post/micr...

Corrections:
-I noticed the user button and reset button in the schematic were rotated 90 degrees from what I had in my mind. See the blog post for additional details.
-Around the one minute forty-eight second mark, I refer to the DC barrel connector a few times as a USB connector.
-The USB connector I was initially using was actually a micro USB-B, and not USB-C.

-----------------------------------------------------------
CHAPTERS:
00:00:00 Intro
00:01:55 Requirements/Constraints
00:03:09 Basic Resources
00:04:17 Starting the Design
00:08:42 Schematic in EasyEDA Pro
01:32:00 PCB Layout in EasyEDA Pro
02:17:10 Routing in EasyEDA Pro
02:51:00 Ordering on JLCPCB
02:56:06 Wrap-up
------------------------------------------------------------


Walkthrough: Building a Small PCB in EasyEDA Pro (BGA CPLD Dev Board)
   • Walkthrough: Building a Small PCB in EasyE...  

Trying Out EasyEDA Pro - Creating a New Component (Device)
   • Trying Out EasyEDA Pro - Creating a New Co...  

GitHub
https://github.com/rehsd/microcontoll...

EasyEDA Pro End-user Guide
https://prodocs.easyeda.com/en/