Скачать или смотреть Making a French Cleat, Wall Mounted, Bottle Opener with Cap Catcher from a Cedar Picket.

I had a customer request I make a bottle opener for him, so I ended up over-engineering it and this is what I ended up with. This will consume about half a cedar picket and a $1.50 bottle opener from Amazon. (About $4 will be your cost to make these)
The 'Improved' French Cleat system has 'drunk' protection from being knocked off thanks to some short side rails.

Sizes can be whatever works for you, but my Cut List is:
14 inch for main body. "Coffin Cuts" at 31.6 degrees on the miter saw.
Front of box, width of picket (5.5 in) by 3.5 in tall.
Box sides and bottoms, 1.75 in wide. 5.5, 3 & 3 inches long.
Cleats are about 3 inches wide, top is 5 inches long with 45 degree bottom cut. Bottom is 7 inches long with 45 degree top cut.

Amazon Affiliate Links:
I will earn a small commission on any purchases made thru the links below at no additional cost to you.

20 Pack Bottle Openers, Wall Mounted, Bronze
https://amzn.to/3ZQr5tU

FastCap PSSR-16 16 Foot Pro Carpenter Standard Reverse Measuring Tape:
https://amzn.to/4tA0FKy

STEALTH 20 Gallon Air Compressor, Ultra Quiet:
https://amzn.to/4apTZ96

Hybrid Lead-in Air Hose 1/4 In. x 10 ft:
https://amzn.to/4rjgNi6

Lavazza Espresso Whole Bean Coffee:
(Yes, I would die without this)
https://amzn.to/4rOdkHV

meite 18 Gauge Brad Nails 1-Inch:
https://amzn.to/4kEY3XW

Titebond III Ultimate Wood Glue, 1-Gallon:
https://amzn.to/4audXj7

Milescraft Glue Mate 15oz. Wood Glue Bottle:
https://amzn.to/4rQb1nX