How To Replace Blower Motor Resistor Connector Plug 1993-1997 Ford Ranger

Buy Now!
New Blower Motor Resistor Connector Plug from 1AAuto.com http://1aau.to/ic/DMZWH00008

This video shows you how to install a new TRQ blower motor resistor connector plug yourself in your 1993-1997 Ford Ranger. The heat and air condition fan is controlled by a separate module, called the blower motor resistor. The nature of this component’s job causes it to heat up frequently, which can lead to failure. If your vents will only blow one speed, this is likely the cause.

This process should be similar on the following vehicles:
1993 Ford Ranger
1994 Ford Ranger
1995 Ford Ranger
1996 Ford Ranger
1997 Ford Ranger

Tools you will need:
• Crimper
• Wire Cutters
• Butt Connectors
• Electrical Tape
• Heat Gun
• Pick http://1aau.to/oa/1AXAA00037

Subscribe:    / @trq  

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.