Скачать или смотреть Part 2: How to Wire an Electric Strike & Card Reader to Brivo ACS100

In my previous video Part 1 of the ACS100 series I gave you an overview of the Brivo ACS100 along with planning tips and key considerations for setup.

👉 In this video (Part 2), I’ll walk you through:
✅ Wiring & Connecting an Electric Strike
✅ Connecting a Card Reader into the Brivo Access Controller (ACS100)

I’ll cover important site preparation steps like surveying door and wall types, routing cables cleanly, following code requirements for low‑voltage wiring, and ensuring proper separation from high‑voltage lines. You’ll also learn:

🔹 How to run Cat5e, Cat6, or 18/6 access control cables
🔹 Why mag locks may require a third‑party power supply
🔹 How to connect Weigand or OSDP readers
🔹 How to wire an electric strike correctly with proper polarity
🔹 ADA height guidelines and best practices for clean, code‑compliant installations

By the end of this video, you’ll know exactly how to wire and connect your Brivo ACS100, ACS300, or ACS6000 series controller.

▶️ Stay tuned for Part 3, where I’ll guide you through mounting and final installation of the ACS100.

💡 For more Brivo tutorials, check out my Brivo playlist here on the channel.
👍 Don’t forget to like, comment, and subscribe to support the channel and get notified when new videos are released!

⚠️ Disclaimer: This video is for educational and demonstration purposes only. Always follow official Brivo documentation and safety guidelines when installing or wiring ACS6000 and ACS6100 systems. Improper installation may result in equipment damage or injury. Proceed at your own risk.

#Brivo #ACS100 #AccessControl #LiveMobileTechnology #ElectricStrike #CardReader #SecuritySystems #WiringGuide #Installation