Скачать или смотреть Quadrax 1.2.0 Beta firmware: synced quad VCO!

For more info about this patch, check out https://modularbeat.com/quadrax-firmw...

Intellijel just released a really exciting beta release candidate for Quadrax 1.2.0 this week that introduces phase resetting for synced LFO/VCOs. I haven't messed with it much, but here's a patch idea I've been thinking about (that I think might work with standard firmware too now that I think about it… not sure what the channel linking behavior did previously). I'm using all four channels of Quadrax at different frequency divisions/multiplications to make a simple monophonic sequence a bit more interesting.

I accidentally left Quadrax in the CV matrix mode so you can't see the mode LEDs, but here is how I set it up:

Quadrax channel 1 is set to LFO with rise modulated by CV A (a short sequence from Marbles).

Audio output from channel 1 goes to my VCA/Mixer, Veils, and also goes back into Trigger 2 🤨

Quadrax channel 2 syncs to Trigger 2 but has rise lowered so it runs an octave lower.

Quadrax channel 3 is linked to channel 2 via the trig sync mode (red) and then rise is adjusted to play a higher pitch (e.g. an octave up)

Quadrax channel 4 is linked to channel 3 via the trig sync mode (red) and then rise is adjusted to play an even higher pitch (e.g. a 5th)

Then I just kind of bring in each oscillator with Veils and play around with the filter. It's a pretty rough sketch of the idea, but it has some potential. There's a lot of glitchy, weird chip tune type sounds possible, especially as you play around with the waveforms and cause the clocking to get freaky.