Fully 3D printed hovercraft - build guide

It is finally here! The build guide for my fully 3D printed hovercraft. After many long months of hard work and through many revisions, I am now happy to release this video.

This is a large speedy and nimble hovercraft that is relatively easy to print, with next to no support material (≈50g of support). All parts are made so they can be printed on an Ender 3 or simular sized printer. The hovercraft is 580mm long, and 280mm wide, both drive motors are mounted on servos which gives the hovercraft great steering authority.

Materials
1,5kg PLA
1x 70mm EDF (FMS 70mm 12-Blades Ducted Fan)
1x 65A brushless ESC
2x Brushless motor (EMax ECO II 2207 2400KV)
2x 35A brushless ESC
2x 5 inch propellers
2x 9gram servo
2x 12x28x8 ball bearing
2x 8x16x5 ball bearing
10x M3 threaded inserts
10x M3 screws 8mm long
16x Round neodymium magnets, 4mm Ø and 2mm thick
1x 4S Lipo 3700mAh 45C Tattu or same sized lipo
80x Balloons (30cm Ø inflated, 50-55mm Ø uninflated)
1x 6 ch transmitter and receiver
Some soldering supplies, wires and battery connector
Epoxy

Print settings
3 perimeters
25% infill
0.2mm layer height
Raft
Manual support

See more on the Printables page,
https://www.printables.com/model/8120...

Links to where I got the electronics, and filament
https://mbs-rcmodels.se/
https://rcflight.se/
https://addnorth.se/