SUPER EASY Homemade Bearing Puller

My circular saw had a faulty bearing that needed to be replaced. It was stuck and I didn't want to damage the shaft so made this puller.
For this you only need a piece of square steel tubing and some nuts and a bolt.
You're also going to need some common tools like a hacksaw, hand drill, wrench, etc.
The best part about this is that you don't need to weld any parts!
I hope this video helps you too.
like and subscribe if you want to support my channel.

tip: make sure you don't overheat your electric tools when using them, otherwise they may end up like this saw with a burnt bearing.


#diy #tool #repair #woodworkingtools #makita #circularsaw #toolmaking #homemade #bearingpuller #bearingremover