DIY Livescope Rotating Mount Build

For a full list with purchase links of all the gear I use go to: https://www.southernreels.com/fishing...

Ok so here is a step by step guide on how I built the rotating mount for my Panoptix Livescope. This was done with parts that are readily available at home improvement stores. Having the rotating mount like this is key to make full use of the Livescopes potential. Total cost for this build is $25.00. All parts used listed below.

Outer PVC Pipe- https://www.lowes.com/pd/Charlotte-Pi...

Inner Pipe- https://www.lowes.com/pd/Silver-Line-...

Outer Pipe T Fitting- https://www.lowes.com/pd/LASCO-90-Deg...

Inner Pipe Top Fitting- https://www.lowes.com/pd/Genova-3-4-i...

Inner Pipe Lower Fitting- https://www.lowes.com/pd/Genova-3-4-i...

Rotating Knob Fitting- https://www.lowes.com/pd/LASCO-1-in-x...

Rotating Knob Cap- https://www.lowes.com/pd/LASCO-1-1-2-...

1.5 Inch Ram Ball Fitting- https://www.rammount.com/part/RAP-294U