Devongunsmith Diaries #2 John MacNab 20 Bore Shotgun Rush Repair

HAVE I TAKEN ON TOO MUCH?
Unavoidably, so close the Christmas holidays, and the Boxing Day shoot, the inevitable rush repair.. suspected light strike, or misfire, an intermittent fault, plus the cartridge manufacturer has some differences in their old and new cartridge stock... far too many variables.. Will my gamble to take this gun on for a rapid repair prove to be too much to take on?
Errata in the video: MacNab Highlanders were made by Batista Rizzini. The MacNab Lowlanders were made by Sabatti

The Devongunsmith Diaries concept was conceived by me during lock down, and the premise was to be able to perform work without a fully set up gunsmiths workshop, but rather, using just the Cottage Kitchen Table, a few hand tools, some cordless tools, a table vice, and other small DIY tools.
While the channel is not specifically intended to be a how to guide, it is mainly for entertainment.
While in the UK gunsmithing must be performed by the Licenced Gun Trade, YouTube is without borders, and if the channel is useful to someone as either entertainment, or indeed helps you to decide if a repair might be possible, then I have been a help to you.
#gunrepairs #sabatti #johnmacnab #gunfit #shotgun #gunsmith #gunsmithing

As an Amazon Associate, I earn from qualifying purchases, this helps the Devongunsmith Channel
The Moly Grease I use is this one: https://amzn.to/46pJ4sP
Bisley do a smaller pack of Moly: https://amzn.to/45xNZqe
The lithium grease I also use: https://amzn.to/3tmh4rh
Light gun oil in a small pack: https://amzn.to/3LYRKOD
The Pipe Pliers use to make my custom coil spring pliers: https://amzn.to/46DzHFE
The Grace USA gunsmith turnscrews I use are these: https://amzn.to/45nIx9q
The Generic version of Mirlon or Scotchbrite I use: https://amzn.to/46rCGRT
Wheeler trigger scales I use: https://amzn.to/3S2sWJz