How To (Mig Weld) and Install a C-Notch (1965 C/10)

In this video I share how I go about installing a c-notch in the chassis of my 1965 c10 pickup. This is a very easy process for the beginner. With a small amount of tools you can do this job with ease. The purpose of the c-notch is to allow the truck to be lowered more, allowing the rear axle to travel up further. This is a great beginner fabrication project!
BELOW are the links to the products used in this video. Some of these are from my amazon affiliate account, I make a small percentage off of qualified products at no additional cost to you. We use a lot of cleaning products from ‪@oreillyautoparts‬ in the video but were not sponsored by them.
ILLUMI-WELD LIGHT Link https://illumiweld.com/?aff=2
‪@speedwaymotors‬ C-Notch https://amzn.to/3PjWBwi
Black hawk cut off wheels https://amzn.to/3PiYNnB
Vulcan Welding Helmet https://amzn.to/3Pj0gdH
Air Hammer https://amzn.to/442ASNx
air grinder https://amzn.to/3XbCW3q
Dewalt grinder https://amzn.to/3Xf1zwi
Dewalt 60 Grit Grinding wheels https://amzn.to/3Xbv7uG