Custom/Bespoke Pen Making- RollerBall Section, Kitless Bespoke Pen Making

In this video Chad goes over making a roller ball section for a custom/kitless bespoke pen, including measurements, tips and tricks. And as you will see in the video he adapts to some difficulties and comes out with a nice section at the end!
Thanks for watching!

Here are the specs for the piece he is working on:
55mm long starting section
9/32 drill bit 35mm (from tenon end)
5mm drill bit 50mm (from tenon end)
2.5mm drill bit through
8mm long cut for Tenon- Used M10x1 (single start) die for cutting threads
Home-made mandrel

Here are links to products seen or talked about in the video:

Tap and Die Sets:
https://www.turnerswarehouse.com/prod...

Drill Bits:
https://www.turnerswarehouse.com/coll...

Niche system:
https://www.turnerswarehouse.com/prod...

Top Choice blanks: (molten metal)
https://www.turnerswarehouse.com/prod...

Record Power Tools (parting tool was used in the video)
https://www.turnerswarehouse.com/prod...

Easy Wood Tools Carbide:
https://www.turnerswarehouse.com/coll...

Collet Chuck system:
https://www.turnerswarehouse.com/prod...

SC3 Record Power Chuck:
https://www.turnerswarehouse.com/prod...

Fine grit wet/dry sandpaper:
https://www.turnerswarehouse.com/prod...

Zona Paper:
https://www.turnerswarehouse.com/prod...

Ring Bling polishing compound
https://www.turnerswarehouse.com/prod...

Record Power Regent Lathe:
https://www.turnerswarehouse.com/prod...