How to wire a Peco Solenoid Motor DC & DCC - Includes intro to DDC Concepts ADS-8SX

In this video I'll show you how to wire a Peco solenoid motor. I'll go over connecting it up to a DCC layout using the DCC Concepts ADS-8SX and then how to connect it to a DC layout using a controller with an accessories output.
The ending is the same as seen in the video for the old Peco, Gaugemaster and the Hornby solenoid motor. Although I use the Gaugemaster solenoid motor to show how to wire it to a DC layout, the wiring is the same for the Peco and Hornby. I'm not using a CDU, these are optional but I don't require them as yet.


Disclaimer
Please be careful when wiring - Components can burn out or short so be sure the power is off and you have read any instructions thoroughly.
Don't just go on my advice - Although I try to be as correct as possible and show you "How to" this is "How I" and there may well be a better way of doing it. Youtube has an abundance of information so always make sure you check more than one source where possible.
Liability - Where possible, I will show you anything I am doing in practice and working. I will check the video for any obvious mistakes and correct them. I cannot take responsibility for any damages caused.