AG01 gimbals now available for Zorro and TX12 Radiomaster radios!

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: https://www.fpvknowitall.com/ultimate...

SUPPORT ME ON PATREON at: http://bit.ly/2Ep5Sia

THIS IS MY FULL TIME JOB. Here are other ways that you can support me: https://www.fpvknowitall.com/support-me/

---

I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below.

Buy the AG01 Mini at:
RadioMaster - https://bit.ly/3KuIXAj

-- TABLE OF CONTENTS --

0:00 - AG01 is finally available for the TX12 and Zorro!
0:46 - What makes the AG01 so special compared to the factory gimbal?
1:54 - The AG01 will not make you a better pilot. But it is nice.
3:22 - Remove 8 screws from the radio back and remove it
4:26 - Remove 4 screws from the mainboard, unplug all plugs, and remove it
5:32 - Remove 4 screws from the old gimbal and remove it
6:13 - Closer comparison of the original vs. AG01 gimbal
6:57 - Install the new gimbal. Both gimbals are identical. There is no left-hand or right-handedness.
8:27 - The difference in feel is not as big as with the larger gimbals
10:45 - Adjust gimbal tension now if you prefer
11:33 - Replace all plugs on mainboard and reinstall it
13:34 - How to tell if you plugged the gimbals in backwards
15:03 - Install the back cover and reinstall screws
15:54 - Adjust throttle centering and tension
16:30 - Have you decided to buy these gimbals?

The right way to calibrate gimbals:    • You're calibrating your gimbals wrong...