Скачать или смотреть DC24V TM1936 RGBWW 5 in 1 Dual Color Temperature Dimmable LED Strip Lights

https://www.superlightingled.com/dc24...

One data line, two power lines, 256 levels of gray, realized by the controller, gradient, water flow, horse racing, text, numbers, English, pictures, animation, etc. any effect.PWM refresh rate: 800kHz, transfer speed 800k bps

1. Control principle: One IC controls one LED to form a loop (a group), and the controller controls the circuit in the FPCB through the control IC to control the different effects of the LED light bar changes, ; such as flicker, chase, jump, Clockwise horse racing, counterclockwise horse racing, monochrome horse racing, color-changing horse racing, single chase from beginning to end, running water, simulated lightning, etc.; the change effect of this light bar is not limited to the multiple effects built in the current controller, and can be based on customer needs, Write by yourself, Controller System：SD controller, DMX controller, Artnet and so on .(SPI protocol); it can be displayed in the form of a screen, text, letters, pictures, animation, etc.

2. Environmental protection and safety: It has the characteristics of low power consumption, low heat generation, no glare, and impact resistance. Low voltage DC 24V, high safety, and reliability.

3. Rich and diverse colors can be adjusted arbitrarily through the controller according to customer needs.

4. Long life span: the average life span is up to 50,000 hours.

5. Cutting and welding are convenient and free: each group of LEDs can form a loop, which can be arbitrarily cut along the upper tangent and welded to meet the needs of various light strip lengths required by customers.

6. Soft: The soft FPCB board is used as the base plate, which can be docked, bent, cut, and fixed on an uneven surface at will. It comes in 1 meter per reel with a 3Pin female/male JST SM connector on both ends and separated Power / Ground Wires. 2unce PCB board with double cooper layer( 35um copper ). double sides membrane covers the PCB board. make sure the copper no drop from the PCB board

7.Installing: screw+silicon clip and 3M adhesive on backside for sticky..