Colorado XT - Front Motor Mount - Version 2

Colorado XT - Front Motor mount version 2. This is an updated design on the front motor mount I designed last year. This version is constructed of 100% PVC and should provide a more rigid frame. I didn't glue much of the version 1 motor mount, but I would recommend gluing this one a bit more. I also have a complete parts list with quantities and measurements at the end of the video.

The total cost of this frame was $26. You may want to spend an extra few dollars for the glue and spray paint (I still need to paint this one). Also, the addition of two bungie cords added to the stability.

Quick Parts List: - All parts 1.25 inch PVC
6 x "T" shaped connectors
4 x "L" shaped connectors
2 x "+" shaped connectors (which will be cut)
63 inches of PVC - Assuming 100% efficiency.
4 x 6.75 inch PVC cuts (for the center to side braces)
8 x 2.25 inch PVC cuts (for connectors)
2 x 9 inch PVC cuts (for bottom extensions or "legs")
I STRONGLY suggest buying more than just the 63 inches of PVC so you have some room for trial and error.

Please comment and let me know if you have any suggestions or modifications.

Thanks for watching!