Скачать или смотреть GoldenEye Remote Mine replica - Lights/Beeping Arduino Code

I created an Arduino code to use for your GoldenEye Remote Mine Replicas. When researching this build I found that a lot of builders were not able to find a good way to reproduce the flashing and beeping pattern properly. Using an Arduino Uno or an Arduino Mini which would probably fit better inside the housing, this code can be utilized. You may adjust the delay to slow up or speed down the lighting pattern and the delay between when one light shuts off in the other turns on. depending on the buzzer, you by you may also adjust the frequency sound of the beep. It is currently set at 4.2KHz. (4200 in the code). Imade this for myself but I figured I'd upload and share.

Enjoy - Code Below

int wait=500;
int LED1=11;
int LED2=9;
int LED3=6;
int LED4=5;
int LED5=4;
int LED6=3;
int BUZZER1=10;

void setup()
{
pinMode(LED1,OUTPUT);
pinMode(LED2,OUTPUT);
pinMode(LED3,OUTPUT);
pinMode(LED4,OUTPUT);
pinMode(LED5,OUTPUT);
pinMode(LED6,OUTPUT);
pinMode(BUZZER1,OUTPUT);

}
void loop()
{
digitalWrite(11,HIGH);
tone(BUZZER1, 4200);
delay(125);
noTone(BUZZER1);
digitalWrite(11,LOW);
delay(80);
digitalWrite(9,HIGH);
tone(BUZZER1, 4200);
delay(125);
noTone(BUZZER1);
digitalWrite(9,LOW);
delay(80);
digitalWrite(6,HIGH);
tone(BUZZER1, 4200);
delay(125);
noTone(BUZZER1);
digitalWrite(6,LOW);
delay(80);
digitalWrite(5,HIGH);
tone(BUZZER1, 4200);
delay(125);
noTone(BUZZER1);
digitalWrite(5,LOW);
delay(80);
digitalWrite(4,HIGH);
tone(BUZZER1, 4200);
delay(125);
noTone(BUZZER1);
digitalWrite(4,LOW);
delay(80);
digitalWrite(3,HIGH);
tone(BUZZER1, 4200);
delay(125);
noTone(BUZZER1);
digitalWrite(3,LOW);
delay(80);


}