Kato Unitrack Turnout Operation using Toggle and Pushbutton Switches

NOTE: THE TWO LEDS CAN BE CONNECTED VIA A SINGLE RESISTOR RATHER THAN TWO SEPARATE RESISTORS

This video covers a basic circuit used to operate a Kato Turnout using a Toggle Switch and a Momentary Pushbutton Switch.
The circuit is explained in detail and then followed by a practical demonstration.
There are various other ways of operating the Kato Turnout, this is the way I did it before I moved over to operating my turnouts using DCC.

You will need:
1 x DPDT ON-ON Toggle Switch (1 per turnout)
1 x Momentary Pushbutton Switch (1 per turnout)
12V DC power supply (I would recommend getting a 2 Amp or greater power supply if you are purchasing a new one)
Wire
Solder

If you want to add LEDs:
2 x Green LEDs (3mm or 5mm)
2 x 680 ohm or 1000 ohm resistors
or
2 x Bipolar LEDs (3mm or 5mm)
2 x 680 ohm resistors

Australian T Trak website https://sites.google.com/view/austral...
T Trak, Ntrak website https://www.ntrak.org
Kato Unitrack website https://www.unitrack-kato.com/