Honda Odyssey Center Rail Door Roller Replacement

Video demonstrating how to replace the centre sliding door roller on a 3rd generation Honda Odyssey (years 2005-2010). Te procedure for replacing the roller is the same for all model years listed. The procedure and part # is the same for all trim levels that have a POWER sliding door. For earlier LX models the procedure is very similar except that there are no cables to remove or reinstall.

This repair procedure is identical for both the drivers and passenger side sliding door.

The procedure should take even the most novice mechanics approximately 1.5 hours.

Supplies you will need:
1. Replacement centre rail roller assembly
2. Small flat blade screwdriver
3. 10 mm socket
4. 12 mm socket
5. Phillips screwdrive
6. Masking tape
7. Shop rags or towel
8. Needle nose pliers
9. Hammer
10. Chassis lube (optional)
11. Hydraulic jack with thick towel or shop rag
12. Helper (to help hold the front drive cable during reinstallation of the new roller).
13. Permanent felt tip marker