Скачать или смотреть DIY Fidget Spinner over 3 min spinning time - 11$- + Hybrid Ceramic Bearing - see describtion

Both fidget spinners were printed on the Anet A8 (i3 clone).
The spinner on the right was printed with a two layer raft during #GPN17.
more infos about model and material...

The bearing on the right is brand new und was used for the first time in this spinner, without oil or lube.
The bearing on the left was used in my previous video and has been cleaned with acetone.

Spinner model:
left: http://www.thingiverse.com/thing:1859911 by MadMax3D
right: https://www.thingiverse.com/thing:179... by Keshyden (Smooth Version)

Center bearing: Hybrid Ceramic: https://www.amazon.de/dp/B071YPQ2Y3/
Outer bearings: 608er 2RS MACH1® High Speed https://www.amazon.de/dp/B00MS7S9FQ

Total cost: (without PLA)
7,89 + 3,00 = 10,89€
This can be reduced by using cheaper outer bearings and getting the ceramic hybrid bearing from china.

Timer: iPod Touch 6th gen (mid 2015)

Video unedited and pulled straight out of the camera.