How to Install a ProClip USA Adjustable Holder

New ProClip Adjustable Holder? Watch this helpful video for a step-by-step tutorial! Install instructions are included with each ProClip device holder. https://www.proclipusa.com/

Step #1: Completely loosen ONLY the one screw in the center of the holder. Then, using light force, pull the base plate away from the back of the holder. This will separate the Device Holder portion from the Tilt-Swivel base plate.

Step #2: Place the base plate over the matching holes on your vehicle mount. Attach the base plate using the self-tapping screws.

Step #3: Place the holder onto the base plate and reattach it with the center screw. The center screw also controls the pivot; tighter for a firm hold and looser for easier rotation/angling of the holder.

Step #4: Slide the device into the holder using the grooves. The bottom of the phone should be flush with the bottom of the holder.

Step #5: Loosen the screws above and below the center hole to release the side arms. Dock your phone with protective case in the holder grooves to adjust for correct width. After sizing for correct width, tighten same screws to lock arms in place. (DO NOT fully remove these screws).

ProClip is a two-piece custom phone mounting solution for your vehicle. The vehicle mount is custom made to fit your specific make, model and year vehicle. The cell phone holder is custom made to your specific device. The two pieces combine to create your in-vehicle phone mount.

Facebook: https://www.facebook.com/proclipusa/?...
Twitter:   / proclipusa  
Instagram:   / proclipusa  

Sign-up for ProClip emails: https://www.proclipusa.com/newsletters

Also be sure to check out the ProClip video here:    • ProClip USA Phone & Tablet Car Mounti...