Скачать или смотреть Single phase full wave uncontrolled rectifier with R load using MATLAB

A single-phase full-wave uncontrolled rectifier with R (resistor) is a circuit that converts AC (alternating current) voltage into DC (direct current) voltage using a diode bridge and a load resistor. The circuit consists of four diodes arranged in a bridge configuration, with the load resistor connected across the output terminals of the diode bridge.

During the positive half cycle of the AC voltage, diodes D1 and D2 are forward biased and conduct current through the load resistor, while diodes D3 and D4 are reverse biased and block current flow. During the negative half cycle of the AC voltage, diodes D3 and D4 are forward biased and conduct current through the load resistor, while diodes D1 and D2 are reverse biased and block current flow.

The load resistor R is used to limit the current flowing through the diode bridge and provide a load for the rectified voltage. The rectified output voltage across the load resistor is not smooth, but rather a pulsating DC voltage with a frequency equal to the AC input frequency. The amount of ripple in the output voltage depends on the value of the load resistor R, as well as the capacitance of any smoothing capacitor connected across the output.

This circuit is commonly used in low power applications such as battery chargers, LED drivers, and small DC motors. However, it is not suitable for high power applications due to its high current ripple and low efficiency. In high power applications, a controlled rectifier or a three-phase rectifier may be used instead.