GL Racing GTR Build- Step 6

GL Racing GTR Build Step 6 (page 10 in the manual). Be careful in getting the correct hardware and don't mix them up! Make sure to use the correct ball cups for the steering turnbuckles! They are not all the same! I removed the ball stud from the servo horn to get enough clearance to install the steering turnbuckles. For the optional front shocks, I installed the ball cups as far as possible until they shouldered up, and they gave me a similar length to the stock shocks. Also, I used 15k grease on the front shocks vs the recommended 30k.

If your local hobby shop carries this, please buy from them. Consider supporting my local hobby shop HoustonRC. All these items should be on their website here:

https://www.houstonrc.net/shop/1-28-o...

Additionally, you can email them the list below to order parts - [email protected]

GL Racing GTR Kit - GL-GTR-SET

Must Have Option Parts -
GL-GTR-OP-004 - GL GTR Alu. Dual Steering Arm with Servo Saver Set
GL-GTR-OP-027 - GL-GTR Hybrid Chassis Set

Nice to Have Option Parts -
GL-GTR-OP-009-2 - GL GTR Alu. Steering Knuckles (2°)
GL-GTR-OP-020 - GL-GTR Screw Adjustable Shock (Front)
GL-GTR-OP-021 - GL-GTR Option Side Dampers

Electronics Gear, ETC -
GBY003 - 2S 360mAh Lipo Battery Pack
HRC2500KV - HoustonRC 2500 KV Sensored Motor
HRC06 Servo - HoustonRC HRC06 Servo
HRC Servo Horn HRC06
HRC3625C - Ceramic Bearings, 3x6x2.5mm (4pcs) (need 2 packs for the car)

Build Supplies -
Hobby Knife - https://amzn.to/46vebmS
Hobby Knife Blades - https://amzn.to/48RNSZC
Inexpensive Soft Jaw Pliers - https://amzn.to/3twgrf5
(The above get the job done, but are very low quality)
Nice Soft Jaw Pliers - https://amzn.to/3LXW6ph
Sanding Sticks - https://amzn.to/3FhOl9R

*Notice: Some descriptions may contain affiliate links, which means that if you click on or use one of the product links/ codes, we may receive a small commission. This helps support the channel and allows us to continue to produce content.