Скачать или смотреть Automatic Scroll Bender GSB 80 P Scroll Ends Rolling up Device GSE 805

The Automatic Scroll Bender GSB 80-P bends forged scrolls in cold condition. Raw materials pre-cut flat, square or round iron, the ends of which have been hot-forged before. The Scroll Bender GSB 80-P contains a pole-reversible arm motor with brake for two different rotating speeds (12 and 24 rotations/min.). The Scroll Bender GSB 80-P is
equipped with the GLASER-Position ControlGPS-2 including a memory for max. 200 locations Each location memorises besides the starting position of the used bending tool, all angles for a special scroll. First information is the first bending angle of the tool and the corresponding release angle for taking out the scroll. Subsequently memorises the data
for bending- and release angle of the second bending. The scroll bending process goes as follows: First the bending tool is turned into its starting position. Then the scroll blank is pushed into the bending tool, and the bending process is started the tool is turned to the programmed end point. So the first bending of the scroll is finished after a short dwell time the tool is released and the bent scroll can be taken out. After that the tool is returned into the starting position. Now, if required, a second bending may follow. In case of a symmetric C-scroll the same procedure is repeated. For an asymmetric S-scroll the bending tool is turned to another end point and released. A simple scroll does not necessitate a second bending.

The control of the Scroll Bender GSB 80-P operates in the modes Adjusting, Hand-Control and Foot-Control. ln the operating mode Adjusting the basic position of a new bending tool is taken over into the Position Control The automatic scroll bending proceeds in the operating modes Hand-Control and Foot-Control. The different memorised locations are successively re-used by pressing a push button or the pedal. Thereafter the bending tool
is turned into the basic position and the next scroll may be bent. The operation with mode Foot-Control is recommendable for the mass-production, thus achieving the utmost output. The Scroll Bender GSB 80-P is mobile.