Intex pool assembly. Tips

Intex pool 12 X 24 pool assembly
Some Notes :
When the pool is in the get ready to pour water in it stages go around and pull all the bottom of the supports to keep the tension on one leg verses the other legs so go around and do it about 3 times that will give you an idea of were the support boards should go. so if you look at about 2.25 in the video the inside top poles are bent in. This is because there is not much water in it so after you have about 6 to 10 inches of water in it go in the pool slide around to get the wrinkles out of the bottom. then go around as your filling it and figure about 8 inches of distance each way is when you should start digging and putting in your support boards if the pool is more that 1 foot high on water it will be harder to lift and dig and put the boards under. so plan early. my boards were 2X6 s and I use 2 of them about 18 inches long . Oh and the Tarp that intex gives you will devolve by the sun in 1 summer . bottom tarps are cheap but cheap is Cheap right !
Oh I don't recommend diatomaceous earth use a good sand for your sand filter check the instructions and don't fill it with too much sand about 1 inch lower than recommend will get you through a Good summers. back wash it every other day for 1 to 2 minutes use

Good Luck Enjoy your pool any other Questions I will be happy to answer.