Homematic IP WLAN Access Point Resetting and deleting the entire installation

Resetting and deleting the entire installation eQ-3

• Disconnect the WLAN Access Point from the
power supply.
• Plug-in the USB mains adapter again and press
and hold down the system button (A) for 4s, until
the LED (A) will quickly start flashing orange.
• Release the system button again.
• Press and hold down the system button again for 4 seconds, until the LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart

Resetting and deleting the entire installation
To reset the factory settings of the entire installation, the
procedure described above must be performed twice in
succession, within 5 minutes:
• Reset the WLAN Access Point as described above.
• Wait at least 10 seconds until the LED (A) perma-
nently lights up blue.
• Immediately afterwards, perform the reset for the
second time by disconnecting the WLAN Access Point from the power supply again and repeating the previously described steps.
After the second restart, your system will be reset