AGL Scratch Built Trainer

In this video, Kevin builds a scratch-built high-wing trainer from simple Dollar Tree foam board and electronics bought from the local hobbyshop (Oak Mountain Hobbies). This is a long video, so you will be seeing a lot of sped up spots. It was only sped up when it was to save time. Anything left was what you would need to know (especially for beginners!). Thanks for watching, and please like, share, and tweet our videos. If you haven't subscribed, please do so that you can see videos as we upload them.


Oak Mountain Hobbies
http://www.oakmountainhobbies.com

Our website
http://www.aglaerial.com

Facebook:
  / aglaerialvid.  .

Link to plans for the Blu Baby plane built in this video
http://www.rcgroups.com/forums/showth...

These are the components we used to assemble this plane
2 sheets Dollar Tree foam board
1 9x4.7 slow fly APC prop
1 Cheeta 2212-10 1400kv 3s motor
1 30amp ESC
3 Hitec HS-55 servos
1 Spektrum 4ch Rx
1 1300mah 3s lipo
4 control horns
linkage rods
Hot glue gun
Fiber reinforced tape