SKREDDY PEDALS || SERENITY FUZZDRIVE || DEMO BY TINKERCITY MUSIC

A video demo of the Skreddy Pedals Serenity Fuzzdrive.

All music written & recorded by Tinkercity Music

SUBSCRIBE to Tinkercity Music:

   / @tinkercitymusic  

Read the "Gearheads Blog" here: https://www.tinkercitymusic.com/gearh...

Smooth and sweet amp-like gain that goes from
cleanish boost to transparent overdrive to
compressed sustain while retaining the guitar's
essential voice throughout

Super good at guitar-volume clean-up; responds gradually and
predictably without changing tone as it cleans up. Can go from mild,
open overdrive to near-infinite sustain, maintaining the guitar's
clarity, sweetness, and eq footprint all along the way.
Class A overdrive / distortion / fuzz with no clipping diodes, no op-
amps, and no active tone controls

Natural EQ footprint with special attention paid to phase integrity of
the audio signal

Volume: Finds unity gain well before noon, depending on the
strength of your pickups. Lots of boost available.

Fuzz: Adjusts the gain of the distortion section for a huge range
between cleanish and mild, cranked-amp-style fuzz.
Hot: Adjusts the input gain; goes from a un-colored tranquil sound
counterclockwise to an aggressive, compressed, boosted sound
clockwise.

Pres: Opens up, or dampens, the top end; neutral in the center,
transparent and bright at full up and mildly dark all the way down
while still retaining the mids. (interactive with volume)

Body: Adjusts the basic nature of the voice via the balance of lower
mids and upper mids going into the distortion stage: neutral at
around 2:00-3:00 o'clock, more articulate and cutting "treble boost"
fully clockwise, thick and smooth at noon, and extra fat and juicy
fully counter-clockwise.

Power

All Skreddy Pedals accept the industry-standard 9v DC plug (5.5mm
barrel x 2.1mm center coax), with the center being negative and the
barrel being positive. Please use a quality, regulated, filtered power
supply. Yes, you can use 18v if you want more punch and clarity.
9v battery is not included. To install or change a battery, remove the
bottom cover using a Phillips screwdriver. To prevent a battery (if
you use one) from draining while the pedal is not in use, remember to
un-plug the input cable from the pedal’s input jack. The battery is
also disconnected from the circuit when an adapter is plugged into
the DC jack.

Power consumption: 1 or 2 mA @ 9v

If you’d like to learn more about Skreddy Pedals please do check out these sites for more information.

https://skreddypedals.com/
  / skreddypedals  
  / skreddypedalsinc