Honda Accord Ignition Switch Replacement

A fastener by fastener tutorial for testing, removing, and installing an ignition switch on a Honda Accord.

I cover how to cause an intermittent switch to act up, test it for continuity to verify it's faulty, and how to remove the cylinder assembly from the vehicle so the electrical switch can be removed.

Then I cover the 1990s to 2000s Honda ignition switch recalls and the special part numbers that go with them and reinstallation of the cylinder assembly to the vehicle.

The shear bolt diameter and thread pitch is M8 X 1.25.

Ignition Switch Recall Info:

Honda TSB Number 02-031

Vehicles affected:

1997 Accord (L4), 1998-1999 Accord (L4 and V6), 1998-2000 Civic, 1997-1999 CRV, 1997-2000 Odyssey, and 1997-1999 Prelude.

Link to the recall PDF with installation diagrams:

http://www.driveaccord.net/PDF/igniti...

"Welcome To The Show" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0 License
http://creativecommons.org/licenses/b...

Due to factors beyond the control of Bushougoma, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Bushougoma assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Bushougoma recommends safe practices when working with the tools or equipment seen or implied in this video. No information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Bushougoma.