Скачать или смотреть Qolsys IQ Panel 4: Wiring and Programming a Zooz ZEN16 MultiRelay

In today's video, Dylan will show you how to wire, include (Z-Wave), and program a Zooz ZEN16 MultiRelay with a Qolsys IQ Panel 4. The Zooz ZEN16 is a suitable replacement for the Fortrezz MIMOLite, which has been discontinued. A big difference between the MIMOLite and the ZEN16 is that the MIMOLite was a Form C relay that could be wired as Normally Open or Normally Closed. The ZEN16 is a Normally Open relay that closes or provides a short when activated. This is referred to as Form B.

00:00 - Introduction
00:30 - Relay Wiring
08:20 - Including ZEN16 with IQ4
12:14 - Manual Relay Test
14:25 - Programming Rules
17:03 - Outro


Our examples in this video show the wiring and programming commonly used when adding a siren or strobe to the system. Most all-in-one alarm systems have either a low-current siren output or no siren output. For users replacing a wired system with a modern all-in-one system, where a high-current wired siren is already in place, adding a relay and a power supply will allow the existing siren to be used.

The examples in this video show the bare minimum rule programming necessary to use the Zooz ZEN16 MultiRelay to activate a siren on the system. In the FAQ linked at the bottom of this description, we provide more information and additional recommended programming. We encourage you to check out the FAQ in addition to the video.

https://www.alarmgrid.com/faq/what-ca...

http://alrm.gd/get-monitored