Swapping a Turbo Honda K24 into a Ferrari 308 GTBi - Ep. 19 - Fabricating New Chassis Tubes

I'm thrilled to finally be at the start of fabrication for this project, although it's off to a slow start... filming and fabricating simultaneously is a challenge!
We've got two new tubes in place in the Ferrari 308, both to provide strength in place of the chassis tubes we cut out in the previous episodes.


StanceWorks 2021 Content Sponsors:
H&R Springs
RS Future
Nitto Tire
Air Lift Performance
CSF Radiators

Be sure to follow StanceWorks on Instagram: @StanceWorks

Follow Mike and his progress in Instagram at @mike_stanceworks

Be sure to support our friends at H&R Springs for helping bring this Honda-swapped Ferrari project to life:
www.hrsprings.com

Last but not least, check out the rest of the gang that helps to make this project happen:
www.rsfuture.com

Timecodes:
00:00 - Intro
00:57 - The Objective
02:09 - Grinding & Cutting
02:28 - Measuring and Cutting DOM Tube
03:37 - Fitting the Tube & Tacking it In
04:35 - An Intro to the Tubing Bender
08:47 - Marking Up the Tube for Coping
09:27 - Coping the Tube
11:46 - The End Result
12:56 - Outro