Скачать или смотреть Custom Fiberglass Subwoofer enclosure

This is the complete process from start to finish on how to create a custom subwoofer enclosure for your car. This was done for a 2020 Camry XSE, but the process will be the same for any vehicle.

Audio: Built For This Full by David Renda

00:00 - Intro
00:11 - Tape layer
00:55 - Chop mat
01:17 - Type of resin
01:54 - First layer of fiberglass
02:45 - Removing the form from the car
03:19 -Layers 2 to 6 of fiberglass
05:44 - Removing tape layer
06:13 - Subwoofer mount
09:14 - Trimming the enclosure
10:04 - gluing the sub-mount in place
10:41 - Enclosure front face
13:05 - Final sanding
13:21 - Final carpet layer
14:21 - Speaker wire installation
15:10 - quick disconnect
15:23 - Velcro installation
15:57 - Final product

List of products used

Some products were bought from stores locally, but I tried to compile a list of similar products. Feel free to substitute anything on this list with another product.

Fiberglass Cloth Mat
https://a.co/d/ajP1twd

Fiberglass Resin + Hardener
https://a.co/d/heNSF8J

Black felt carpet
https://www.amazon.ca/dp/B095PCFRDS?r...

2” paint brush
https://www.homedepot.ca/product/hdg-...

Mixing cups
You don’t necessarily need these. I just used plastic drinking cups. Just make sure to test it before using to check if the resin will dissolve the plastic. I haven’t used the product below, but it is advertised specifically for mixing resin.
https://a.co/d/0jYW7eO

Quick disconnect – This is what I used, but I would not recommend. The wire isn’t 100% secure, and can be pulled out.
https://www.homedepot.ca/product/idea...

Would recommend a lever nut instead
https://www.homedepot.ca/product/wago...

Masking tape
https://www.homedepot.ca/product/scot...

Acetone
https://www.homedepot.ca/product/solv...

Plywood
https://www.homedepot.ca/product/1000...

Spray Adhesive
https://www.homedepot.ca/product/gori...

Trigger Clamp (C Clamp)
https://www.homedepot.ca/product/gori...

Hook and Loop fastener (AKA Velcro strip)
https://www.homedepot.ca/product/velc...

Miscellaneous
• Stir stick
• Grinder – To cut final shape and to smooth out stray fibers
• Staple Gun – To secure felt
• Hot glue gun – To secure felt
• Jig saw – Cut out speaker mounts
• Drill and Drill bits – drill hole for speaker wire
• Utility Knife – to cut out a hole in the felt for the subwoofer
• Marker
• Cardboard or plastic liner to protect your work area and trunk from dripping resin
• Face mask
• Gloves
• Safety glasses
• Scissors