Xterra Titan Swap Full Suspension Installation

Hello and welcome to another xtera video ! In this video I an finally working on upgrade my full suspension by doing a Titan Swap that I bought from Nisstec Lifts. It took me some time I had some issues but in the end it all got done ! hope you guys enjoy this video and might find it helpful !
Make sure you install upper control arm boll joins in correct orientation! one side had to be changed when I went for alignment

Full kit bought from Nisstec Lifts ( Company closed down )
https://nissteclifts-com.3dcartstores...

Alternative options
http://xterraperformance.com/05-Xterr...
https://www.z1offroad.com/lift-kits/t...
https://www.alldogsoffroad.com/alldog...



LEXIVON 1/2-Inch Drive Click Torque Wrench 25-250 Ft-Lb
https://amzn.to/2WVp8PS

Video Chapters
00:00 Intro
2:18 Preparation
3:40 Front Disassembling
19:34 Front Assembling
42:09 Rear Disassembling
46:06 Rear Assembling
54:54 The End


Second Gen Nissan Xterra Torque Specs

Front Suspension:

LCA Bump Stop: 14 ft-lbs
LCA Cam Bolt: 100 ft-lbs
LCA Ball Joint Nut: 70 ft-lbs
UCA Mount Bolt: 94 ft-lbs
UCA Ball Joint Nut: 58 ft-lbs
Lower Shock Mount: 155 ft-lbs
Upper Shock Mount Nuts: 22 ft-lbs ( 3 nuts/bolts)
Center Hub Nut: 101 ft-lbs (Replace Cotter Pin After Removal)

Rear Suspension:

Upper Shock Mount Nut: 33 ft-lbs
Lower Shock Mount: 148 ft-lbs
Spring Shackle: 77 ft-lbs (Both upper and lower)
Front Leaf Spring Mount Bolt: 84 ft-lbs
Axle U-Bolt Nuts: 53 ft-lbs


All gear used to to make this video

DJI OSMO Action = https://amzn.to/3v21Mnb
SanDisk 128GB Extreme microSDXC = https://amzn.to/3v4dEF9
PGYTECH Camera Cage = https://amzn.to/3ehjRXJ
Saramonic SR-XM1 3.5mm = https://amzn.to/3gmyvzm
Dual USB-C 3.5mm Mic Adapter = https://amzn.to/2QERrOY
Neewer 50-In-1 Action Camera Accessory Kit = https://amzn.to/3tI5ySg
Neewer Battery Charger Set = https://amzn.to/3glcuRv

Thank you very much for watching !