Simple 3.7 volt battery charger with auto cut off

In this video, I will show you how to make 3.7 volt 18650 battery charger auto cut off with constant voltage & current, using very few components at home.

Check the electronic components you need here: https://bit.ly/3rLO35N
Utsource is a professional electronic components supplier.
More than 800 original brands, More than 6 million original products


Subscribe It's Free ❤️
   / creativetechos  

Required Components For This 3.7 volt battery charger circuit.

1. MJE13005 Transistor or (Any NPN).
2. TL431 Shunt Regulator.
3. 2x 1 Kilo Ohms Resistors (1/4w).
4. 680 ohms Resistor (1/4w).
5. 47 & 470 ohms Resistors (1/4w).
6. Anode Bi Colour LED (Green + Blue).
7. Recommended to make on Pref Board.


IC chip: https://www.utsource.net
IGBT: https://www.utsource.net/category/ele...
electronic component: https://www.utsource.net
Capacitor: https://www.utsource.net/category/pas...
diode: https://www.utsource.net/category/ele...
find chips: https://www.utsource.net
Transistors: https://utsource.net/category/elec-co...
Darlington: https://www.utsource.net/category/ele...
Sensors: https://www.utsource.net/home/sensors"

Circuit Diagram & PCB layout, Gerber Files Download link
https://drive.google.com/file/d/1JqQC...

Join fb Group:   / 819126578700997  

Follow Page:   / creativetechvids  

Pinterest:
https://pin.it/4e3XuVu


Thanks For Watching
✅LIKE
✅SHARE
✅ COMMENTS
✅ SUBSCRIBE


I hope this video was Useful and you liked it if you did press the thumbs up button.
(Creative Techos)

#batterycharger #18650 #Electronics #Circuit #Projects