Скачать или смотреть (Sponsored) STM32 Programming via USB (DFU) - Phil's Lab #72

How to flash firmware via USB to STM32 devices via DFU (device firmware upgrade) and STM32 Cube Programmer. This way you do not need an ST-Link or similar programmer to flash firmware - however, you cannot set breakpoints, debug, and so on.
Note: this is only supported on certain STM32 microcontrollers (check the datasheet!).

(AD: This video includes a paid promotion for JLCPCB and Altium.)

[SUPPORT]
Free trial of Altium Designer: https://www.altium.com/yt/philslab (AD)

PCBA from $0 (Free Setup, Free Stencil): https://jlcpcb.com/RHS (AD)

Patreon:   / phils94  

Mixed-signal hardware design course: https://phils-lab-shop.fedevel.education (WERBUNG)

[GIT]
https://github.com/pms67

[TIMESTAMPS]
00:00 Introduction

00:24 Altium Designer Free Trial (Ad)
00:43 JLCPCB and Git Repo (Ad)

01:08 STM32 DFU Overview

01:58 Test Firmware
02:38 Generating Binaries

03:19 STM32CubeProgrammer and Flashing (BOOT0=1)
04:37 Run Mode (BOOT0=0)

ID: QIBvbJtYjWuHiTG0uCoK