Скачать или смотреть QAV180 Speed Build

Build video of the QAV180 frame. I filmed almost the entire build and sped up the video where not much interesting is going on. At the end of various steps the video is slowed down to show work completed.

Note the captions at each section of the video for reference.

I decided to use a Flip32 board (no pins) instead of a Naze32 board this time around. I directly soldered all wires directly to the Flip32 without any connector pins. This lets me shove all motor signal wires, ESC wires and other power wires in between the Flip32 and the PDB.

Also the Flip32 was installed upside down and rotated counter clockwise 90 degrees to allow the USB port to come out the back and also keep the chips from being exposed.

This is a fairly easy build and only took me about 4 hours.

If there are any questions about anything that might be unclear, please feel free to leave a comment below. I will try and clarify as best I can.

Parts List:
QAV180 Frame - http://goo.gl/8b5vK0
DYS 20a OPTO ESC - http://goo.gl/5RcHcg
EMAX RS2205 motors - http://goo.gl/tsmRC3
Flip32 FC - http://goo.gl/qtQs2i
FrSky D4R-ii Receiver - http://goo.gl/EnL56M
TS5823 200mW vTX - http://goo.gl/m1xRc2

MY GEAR:
RunCam2 - http://goo.gl/UF6Pw7
Xiaomi Yi Action Camera - http://goo.gl/u30TkK
FrSky Taranis X9D Plus - http://goo.gl/W6VNL3
Fatshark Dominator V3 Goggles - http://amzn.to/206Ruwn

What I use to edit my videos - http://amzn.to/1VJHWp7
What I use to film my videos - http://amzn.to/1oNXBth

SUBSCRIBE TO MY CHANNEL - http://goo.gl/b1cZZM

"Relaxing Piano Music" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0 License
http://creativecommons.org/licenses/b...