Rigol DHO924S custom logic analyzer probe, 16 channel (PLA2216 substitute)

16 Channel, custom logic analyzer probe for the Rigol MSO5000, DHO800 and DHO900 series oscilloscopes (CMOS/TTL).

Some notes from the seller's ebay listing (https://www.ebay.com/itm/225976884739) are provided below:

What You Need to Know

The line driver part is SN65LVDS1DBV. They have 5V tolerant inputs. High level is 2-5V. Low level is 0-0.8V. Through current limiting or voltage dividing, it may be possible to exceed the specified range at the loss of some bandwidth. While not supported, testing has shown that the chips can survive exposure to input voltage as high as 10V.

As you can tell from the photos, this probe works best at up to around 100 MHz when used with a MSO5000 oscilloscope. There appears to be an increasing amount of jitter past that point. The cutoff was slightly above 475 MHz. I was using a sine waveform biased between the transition points. If you have some other use for this board, the design should be usable far past 100 MHz. Up to at least 500 MHz. The line drivers are 600 MHz parts.