Knife Spine Metal Etching with salt water and a 12 volt battery charger

Knife Spine Metal Etching with salt water and a 12 volt battery charger. We use a craft vinyl cutting machine to cut out the self adhesive vinyl stencils for the metal etching. This how-to video details how the art is created and or imported into the Cameo Silhouette program and then cut into very detailed stencils. We then use a 12 volt automotive battery charted and a little salt water to etch all areas not protected or covered by the vinyl. The knife spine was etched with a 3d chain links but knife makers can use the same technique can be used to etch almost any pattern.

These knife blanks are available for sale on www.diyeasycrafts.com

Check out this link to order the same 3/16 thick, 1095 high carbon steel knife blank used to create the cleaver used on this video. http://www.diyeasycrafts.com/diy-knif...

Dan's How to Knife making videos
   • DIY Knives and Knife Making  

Custom Knives by Dan Berg
https://bergknifemaking.com

Introduction to Knifemaking Book by Dan Berg and Jason Northgard
https://bergknifemaking.com/products/...

Tilt Table Bevel Grinding Jig by Dan Berg and Jason Northgard
https://bergknifemaking.com/products/...

Complete Online Guide to Knifemaking
https://bergknifemaking.com/pages/the...

Berg Knifemaking Instagram
https://instagram.com/bergknifemaking...

FACEBOOK group Knives and Knife Making
  / 32454.  .

PINTEREST   / .  . #DIYeasycrafts

#knifemaking #knifemakingcommunity #customknifemaking #knifehandle #diyeasycrafts