Скачать или смотреть How to Remove or Install ANY Notary Seal Embosser Insert (Trodat Ideal Shiny MaxSeal Acorn MaxLight)

To remove, replace or install the insert (die/embossing plate) of a notary embosser with a handle like a Trodat Ideal Seal or similar handheld/desktop model, follow these general steps. These inserts are often called die plates, seal inserts, or embossing inserts.
How to Remove REPLACE the Insert from a Notary Embosser
You’ll need:
Clean hands or gloves (to avoid skin oils)
A flat surface
Possibly a flathead screwdriver (optional, depending on model)
Step-by-Step (Common to Most Models like Trodat, Shiny, Ideal, etc.)
Open the embosser
Squeeze the handle to open the embosser so the jaws (dies) are visible.
Lock it open if your model has a lock switch.
Locate the insert
Look for the embossing die insert on both the top and bottom jaws.
One side (usually the bottom) holds the raised insert (male), and the other holds the depressed insert (female).
Remove the insert
For models like Trodat Ideal Seal, you may:
Press firmly inward on the insert and slide it to the side.
Or, gently pry up using your fingers or a flathead screwdriver to pop it out.
Be careful not to bend the die.
Remove both top and bottom inserts
You must remove both matching parts (top and bottom) for proper alignment.
How to Install a New Insert
Align the top and bottom die correctly
Make sure the orientation is correct (most have a notch or guide pin).
The bottom insert should be the female (concave) die; the top is the male (raised) side.
Snap or slide into place
Press the insert into the slot or slide it in (depending on the model).
It should fit snugly with no wiggle room.
Test alignment
Close the embosser on a scrap paper and check the imprint.
Adjust if the die seems off-center or upside-down. #notarystamp

Disclaimer: As an Amazon Associate I earn from qualified purchases.