Chevy Bolt EV STEERING GEAR Replacement *2019 * NO DEALERSHIP * HOW TO SAVE UP TO $2500*

Today we're replacing a steering gear (rack and pinion) on a 2019 Chevy Bolt EV. This is a general overview of a "how to" to remove the steering gear from the drivers side wheel well, WITHOUT completely dropping the entire cradle from the car or going to the dealership. SAVE UP TO $2500

*If the video was helpful, remember to give it a "thumbs up" and consider subscribing for future videos.*

Required Tools

Safety glasses
Two-Three jack stands of at least 2 tons each
Two high quality jacks, which you can accurately control how quickly they lower things; you'll need to slowly and controllably lower the sub frame
1/2" Impact gun or ratchet
1/2" 18mm and 19mm deep well sockets
1/2" 21mm socket
3/8" Impact gun or ratchet
3/8" 12mm deep well socket
3/8" 7mm, 10mm
3/8" 15mm socket, with approximately 2ft of 3/8 extensions
10mm wrench
18mm open-ended wrench
Torx T15 bit
6mm Allen key
Small, large or medium flat head screw drivers
1 plank of wood to support the motor with

Disclaimer: Due to factors beyond the control of Trucks, Cars and Coffey, I cannot guarantee against improper use or unauthorized modifications of this information. Trucks, Cars and Coffey assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Trucks, Cars and Coffey recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Trucks, Cars and Coffey, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Trucks, Cars and Coffey.